LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2016 >> Cascada Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Keyless Entry System And Remote Functions) >> Diagnostic Information and Procedures >> Keyless Entry System Malfunction (Active - without LUK) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2016 Chevrolet Malibu Limited. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that the vehicle key is correct for the vehicle. This can be accomplished by comparing the part number printed on the key to the appropriate part number in the parts catalog.
    • If the vehicle key is incorrect 

      Replace the vehicle key.

    • If the vehicle key is correct 
  2. Ignition OFF, disconnect the keyless entry antenna coax cable from the K77 Remote Control Door Lock Receiver and from the T23 Radio Antenna Amplifier.
  3. Verify the antenna coax cable passes the coax cable component test. Refer to Component Testing .
    • If the coax cable does not pass the test 

      Replace the antenna coax cable.

    • If the coax cable passes the test 
  4. Connect the antenna coax cable to the K77 Remote Control Door Lock Receiver, ignition ON.
  5. Test for greater than 4.5 V between the antenna coax cable center terminal and ground.
    • If 4.5 V or less 

      Replace the K77 Remote Control Door Lock Receiver.

    • If greater than 4.5 V 
  6. Connect the antenna coax cable to the T23 Radio Antenna Amplifier.
  7. Operate the transmitter while observing the scan tool Key Fob Function parameter for the appropriate transmitter.
  8. Verify the scan tool Key Fob Function parameter corresponds with the function selected on the transmitter.
    • If the Key Fob Function parameter does not correspond with the transmitter selection 
    1. Replace the vehicle key.
      NOTE: Before replacing the transmitter, inspect the transmitter battery contacts for any corrosion or damage. If no corrosion or damage is found, replace the transmitter battery and retest before replacing the transmitter.
    2. Operate the new transmitter while observing the scan tool Key Fob Function parameter for the transmitter.
    3. Verify the scan tool Key Fob Function parameter correspond with the function selected on the transmitter.
      • If the Key Fob Function parameter does not correspond with the transmitter selection, replace the K9 Body Control Module
      • If the Key Fob Function parameter corresponds with the transmitter selection
    4. All OK.
    • If the Key Fob Function parameter corresponds with the transmitter selection 
  9. All OK.
scientia non olet · About LEMON Manuals