Circuit/System Testing

Ignition OFF, disconnect the harness connector at the S134 Folding Top/Global Window Switch. Ignition ON
Verify that a test lamp does not illuminate between the signal circuit terminals listed below and ground:
- Signal circuit terminal 7
- Signal circuit terminal 8
- If the test lamp is ON
1. Ignition OFF, disconnect the harness connector at the K9 Body Control Module, ignition ON.
2. Test for less than 1 V between the signal circuit and ground.
  - If 1 V or greater, repair the short to voltage on the circuit.
  - If less than 1 V, replace the K9 Body Control Module.
- If the test lamp is OFF
Test or replace the S134 Folding Top/Global Window Switch.