Circuit/System Testing

Ignition OFF, disconnect the harness connector at the S48D Multifunction Switch 2 - Instrument Panel. It may take up to 2 minutes for all vehicle systems to power down.
Test for less than 10Ω between the S48D Multifunction Switch 2 - Instrument Panel ground circuit terminal 15 and ground.
- If 10Ω or greater
1. Test for less than 2Ω in the ground circuit end to end.
  - If 2Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2Ω, repair the open/high resistance in the ground connection.
- If less than 10Ω
Ignition ON.
Verify the scan tool Lane Departure Warning Switch Status parameter is Open.
- If not Open
1. Ignition OFF. Disconnect the K109 Frontview Camera Module.
2. Test for infinite resistance between the S48D Multifunction Switch 2 - Instrument Panel signal circuit terminal 12 and ground.
  - If less than infinite resistance, repair the short to ground on the circuit.
  - If infinite resistance, replace the K109 Frontview Camera Module.
  - If Open
Install a 3A fused jumper wire between the signal circuit terminal 12 and ground circuit terminal 15.
Verify the scan tool Lane Departure Warning Switch Status parameter is Closed.
- If not Closed
1. Ignition OFF, remove the jumper wire, disconnect the harness connector at the K109 Frontview Camera Module, ignition ON.
2. Test for less than 1V between the signal circuit and ground.
  - If 1V or greater, repair the short to voltage on the circuit.
  - If less than 1V
3. Ignition OFF
4. Test for less than 2Ω in the signal circuit end to end.
  - If 2Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2Ω, replace the K109 Frontview Camera Module.
- If Closed
Test or replace the S48D Multifunction Switch 2 - Instrument Panel.