LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2014 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 403 (Programming And Setup - All Systems) >> Repair Instructions >> K20 Engine Control Module: Programming and Setup (LUZ) >> Reprogram Control Module

Reprogram Control Module

WARNING: This page is about a different car, the 2014 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.

To reprogram an existing ECM, perform the following procedure:

  1. Access the Service Programming System (SPS) and follow the on-screen instructions.
  2. On the SPS Supported Controllers screen, select Engine Control Module - Programming and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select Engine Control Module - Setup and follow the on-screen instructions.
  4. On the SPS Supported Controllers screen, select Engine Control Module - Configuration and follow the on-screen instructions.
  5. On the SPS Supported Controllers screen, select Engine Function - Learn/Setup and follow the on-screen instructions.
  6. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
  7. With a scan tool, reset the Engine Oil Life Remaining back to the original percentage recorded before the control module was replaced, if available.
scientia non olet · About LEMON Manuals