LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2013 >> Encore Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Lighting System) >> Diagnostic Information and Procedures >> DTC B3883: License Plate Lamp >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2016 Chevrolet Trax and 2016 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, exterior lamps OFF, rear hatch latch latched, remove both E7 License Plate Lamp Bulbs.
  2. Test for less than 5 Ω between each ground circuit terminal 2 and ground.
    • If 5 Ω or greater 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • If less than 5 Ω 
  3. Connect a test lamp between the E7L License Plate Lamp - Left control circuit terminal 1 and ground, ignition ON.
  4. Verify the test lamp turns ON and OFF when commanding the License Plate Lamps ON and OFF with a scan tool.
    • If the test lamp is always OFF 
    1. Ignition OFF, disconnect the X4 harness connector at the K9 Body Control Module.
    2. Test for infinite resistance between the control circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the control circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K9 Body Control Module.
    • If the test lamp is always ON 
    1. Ignition OFF, disconnect the X4 harness connector at the K9 Body Control Module, ignition ON.
    2. Test for less than 1 V between the control circuit terminal and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the K9 Body Control Module.
    • If the test lamp turns ON and OFF 
  5. Ignition OFF.
  6. Connect a test lamp between the E7R License Plate Lamp - Right control circuit terminal 1 and ground, ignition ON.
  7. Verify the test lamp turns ON and OFF when commanding the License Plate Lamps ON and OFF with a scan tool.
    • If the test lamp is always OFF 
    1. Ignition OFF, disconnect the X4 harness connector at the K9 Body Control Module.
    2. Test for infinite resistance between the control circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the control circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
    • If the test lamp turns ON and OFF 
  8. Test or replace the appropriate E7 License Plate Lamp Bulb.
scientia non olet · About LEMON Manuals