LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2012 >> Verano >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> DTC P0622 >> Circuit/System Testing

Circuit/System Testing

  1. Verify that a test lamp illuminates between the G13 generator B+ output circuit terminal A X1 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  2. Ignition OFF, disconnect the X2 harness connector at the G13 generator.
  3. Ignition ON, verify the scan tool ECM GEN-F Terminal Signal parameter displays less than 5 percent.
    • If greater than the specified range, test the signal circuit terminal 2 for a short to voltage. If the circuit tests normal, replace the K20 ECM.
  4. Install a 3 A fused jumper wire between B+ and the signal circuit terminal 2.
  5. Verify the scan tool ECM GEN-F Terminal Signal parameter displays greater than 95 percent.
    • If less than the specified range, test the signal circuit terminal 2 for a short to ground or an open/high resistance. If the circuit tests normal, replace the K20 ECM.
  6. If the circuit tests normal replace the G13 generator.
scientia non olet · About LEMON Manuals