LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2012 >> Regal GS, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Fuel Tank Heat Shield Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Fuel Tank Shield
    GM2020148Courtesy of GENERAL MOTORS COMPANY
  1. Attach the fuel tank shield (1).
    2. Fig 2: Fuel Tank Shield Retainer
    GM2020147Courtesy of GENERAL MOTORS COMPANY
  2. Insert the fuel tank shield retainer (1).
  3. Have assistants support either side of the fuel tank.
  4. Place a suitable adjustable jack under the fuel tank.
  5. Have the assistants rest the fuel tank on the adjustable jack.
  6. Once the tank is clear of the frame, upper the fuel tank high.
    7. Fig 3: Fuel Pump Module Wiring Harness Electrical Connector
    GM2020143Courtesy of GENERAL MOTORS COMPANY
  7. Disconnect the fuel tank fuel pump module wiring harness electrical connector (1), from the fuel tank fuel pump module.
    8. Fig 4: Fuel Tank Strap Fastener And Straps
    GM2020142Courtesy of GENERAL MOTORS COMPANY
  8. Install the fuel tank straps fastener (2) and fastener (1).
    9. Fig 5: Evaporative Emission Canister Purge Pipe
    GM2020141Courtesy of GENERAL MOTORS COMPANY
  9. Connect the evaporative emission canister purge pipe (1). Refer to Plastic Collar Quick Connect Fitting Service .
  10. Connect the fuel feed pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
    11. Fig 6: Chassis Fuel Feed Pipe
    GM2020139Courtesy of GENERAL MOTORS COMPANY
  11. Connect the fuel tank feed pipe (2) and lock quick connect fitting (1). Refer to Plastic Collar Quick Connect Fitting Service .
    12. CAUTION:

    Refer to Fastener Caution .

  12. Connect the fuel tank filler pipe (4) to the filler pipe retainer (3) and tighten to 4 N.m (35 lb in).
  13. Refill the fuel tank.
scientia non olet · About LEMON Manuals