Installation Procedure
WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Install the upper bolt into the APP sensor assembly.
- Install the APP sensor assembly into the vehicle.
- Install the remaining 2 lower APP sensor assembly bolts.
Tighten
Tighten the bolts to 8 N.m (71 lb in).
- Install the I/P wiring harness electrical connector (2) to the APP sensor assembly.
- Install the driver knee bolster. Refer to Driver Knee Bolster Replacement (Acadia) , Driver Knee Bolster Replacement (Enclave) or Driver Knee Bolster Replacement (Traverse) .
- Install the left I/P insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
CAUTION:
Refer to Fastener Caution .