LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2011 >> Regal CXL >> Repair and Diagnosis >> Engine Performance >> System >> Data Communications System >> Diagnostic Information and Procedures >> Scan Tool Does Not Communicate with High Speed GMLAN Device >> Circuit/System Testing >> Testing the DLC Serial Data Circuits for an Open

Testing the DLC Serial Data Circuits for an Open

  1. Ignition OFF, disconnect the harness connectors at the body control module (BCM).
  2. Test for less than 2 Ω on each serial data circuit between the DLC and the BCM.
    • If greater than the specified range, test the circuit for an open/high resistance.
  3. Test for less than 2 Ω on each serial data circuit between the BCM and the first splice or splice pack.
    • If greater than the specified range, test the circuit for an open/high resistance.
  4. If the circuits test normal, replace the BCM.
scientia non olet · About LEMON Manuals