Installation Procedure
WARNING:
In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
- Apply a few drops of clean oil to the male connection end.
- Push both sides of the quick-connect fitting together in order to cause the retaining tabs to snap into place.
- Once installed, pull on both sides of the quick connect fittings in order to ensure that the connection is secure.