LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Lucerne Super >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 4.6L - Introduction >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Fuel Level Sensor Wiring Harness Electrical Connector
    GM1671971Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank pressure sensor.
  2. Connect the fuel level sensor wiring harness electrical connector (1) to the fuel tank pressure sensor.
    3. Fig 2: Identifying Fuel Sender Access Hole Cover
    GM1671970Courtesy of GENERAL MOTORS CORP.
  3. place the fuel sender access hole cover into position.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the fuel sender access hole cover bolts.

    Tighten:  Tighten the bolts to 2 N.m (18 lb in).

  5. Install the rear compartment liner. Refer to Rear Compartment Trim Panel Replacement .
scientia non olet · About LEMON Manuals