LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Lucerne Super >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 4.6L - Introduction >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying CMP Sensor
    GM1672561Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the CMP sensor O-ring seal with clean engine oil.
  2. Install the CMP sensor.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Identifying CMP Sensor Wiring Harness Connector
    GM1672927Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector (1) to the CMP sensor.
scientia non olet · About LEMON Manuals