LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Current Sensor Replacement (L26) >> Installation Procedure

Installation Procedure

    Fig 1: Battery Current Sensor
    GM2065396Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the tape tab is pointing away from the battery prior to installation.
  1. Slide the NEW battery current sensor (1) up onto the negative battery cable.
  2. Using NEW tie straps and electrical tape (2), attach the battery current sensor (1) to the negative battery cable.
    3. Fig 2: View Of Right Side Of Engine Compartment
    GM1552765Courtesy of GENERAL MOTORS CORP.
  3. Install the negative battery cable. Refer to Battery Negative Cable Replacement (L26) .
  4. Connect the I/P harness electrical connector (2) to the battery current sensor (1).
scientia non olet · About LEMON Manuals