LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Repair Instructions >> Windshield Wiper System Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Wiper Drive System Module & Screws
    GM815220Courtesy of GENERAL MOTORS CORP.
  1. Position the wiper drive system module to the vehicle.
  2. Connect the wiper motor electrical connector.
  3. Rotate the wiper drive system module to the mounting position.
    4. NOTE: Refer to FASTENER CAUTION .
  4. Install the wiper drive system module screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  5. Install the wiper transmission link to the wiper motor crank arm using the J 39529  .
  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  7. Inspect the wipers for proper operation.
scientia non olet · About LEMON Manuals