Digital Radio Receiver Replacement

WARNING: This page is about a different car, the 2010 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Digital Radio Receiver

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the left rear quarter trim panel. Refer to Rear Compartment Side Trim Replacement - Left Side .
1	Digital Radio Receiver Nut (Qty: 2) CAUTION: Refer to Fastener Caution . Tip: The nuts only need to be loosened enough so that the receiver can be moved so that the nuts will fit through the keyhole slot to remove. Tighten: 10 N.m (89 lb in)
2	Digital Radio Receiver Assembly Procedure Disconnect the antenna cable and electrical connectors. Reprogram the digital radio receiver after installation. Refer to Control Module References .

Callout

Component Name

Preliminary Procedure:
Remove the left rear quarter trim panel. Refer to Rear Compartment Side Trim Replacement - Left Side .

Digital Radio Receiver Nut (Qty: 2)

CAUTION: Refer to Fastener Caution .

Tip: The nuts only need to be loosened enough so that the receiver can be moved so that the nuts will fit through the keyhole slot to remove.

Tighten: 10 N.m (89 lb in)

Digital Radio Receiver Assembly

Procedure

Disconnect the antenna cable and electrical connectors.
Reprogram the digital radio receiver after installation. Refer to Control Module References .