Installation Procedure
- Install the power steering gear through the left wheel opening.
- Install the power steering gear mounting bolts.
Tighten: Tighten the power steering gear mounting bolts to 95 N.m (70 lb ft).
- Install the left stabilizer shaft insulator. Refer to Stabilizer Shaft Insulator Replacement .
- Install the power steering pressure and return hoses (1, 2) to the power steering gear.
Tighten: Tighten the power steering pressure and return hoses to 30 N.m (22 lb ft).
- If equipped, connect the variable effort steering electrical connector.
- Install the outer tie rod (1) to the steering knuckles.
- Install the outer tie rod retaining nuts.
Tighten: Tighten the outer tie rod retaining nuts to 30 N.m (22 lb ft) plus an additional 180 degrees.
- Connect the intermediate shaft to the power steering gear.
- Install the intermediate shaft lower pinch bolt.
Tighten: Tighten the intermediate shaft lower pinch bolt to 47 N.m (37 lb ft).
- Install the power steering gear heatshield. Refer to Steering Gear Heat Shield Replacement .
- Install the tires and wheels. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Remove the J 42640 from the steering column.
- Bleed the power steering system. Refer to Power Steering System Bleeding .
- Check the power steering system for leaks.
- Adjust the front toe. Refer to Front Toe Adjustment .
NOTE:
Refer to Fastener Notice
.