Circuit/System Testing

Ignition OFF, disconnect the harness connector at the EBCM.
Test for less than 1 ohm between the ground circuits listed below and ground.
- Terminal 45
- Terminal 16
- If greater than the specified range, test the ground circuit for an open/high resistance.
Ignition ON, verify that a test lamp illuminates between the B+ circuits listed below and ground.
- Terminal 31
- Terminal 2
- If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the B+ circuit fuse is open, replace the BPMV.
If all circuits test normal, replace the BPMV and verify DTC does not reset. If the DTC resets replace the EBCM.