LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2008 >> Allure CX >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.8L - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

  1. Install the camshaft position sensor to the engine front cover.
    2. Fig 1: View Of Electrical Connector To CMP Sensor
    GM389047Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the camshaft position sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  3. Connect the electrical connector (2) to the camshaft position sensor (1).
  4. Install the drive belt. Refer to Drive Belt Replacement (L26) .
  5. Install the coolant recovery reservoir. Refer to RADIATOR INLET HOSE REPLACEMENT (L26) .
scientia non olet · About LEMON Manuals