LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Rendezvous CX >> Repair and Diagnosis >> Brakes >> Antilock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Installing Hub & Bearing Assembly - Rear
    GM230412Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The rear wheel speed sensors and rings are integral with the hub and bearing assemblies.
    If a speed sensor or a ring needs replacement, replace the entire hub and bearing assembly. Refer to Wheel Bearing/Hub Replacement - Rear .
  1. Raise and support the vehicle on a suitable hoist. Refer to Lifting and Jacking the Vehicle .
  2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear wheel speed sensor electrical connector located next to the rear strut.
  4. Remove the hub and bearing assembly (1). Refer to Wheel Bearing/Hub Replacement - Rear .
scientia non olet · About LEMON Manuals