LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CXS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Locating Air Cleaner Bolts
    GM1404635Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the air cleaner with the MAF sensor.

    Install the air cleaner bolts.

    Tighten:  Tighten the air cleaner bolts to 10 N.m (89 lb in).

  2. Install the TCM with the wiring harness to the air cleaner.
  3. Connect the MAF sensor electrical connector.
    4. Fig 2: View Of Air Cleaner Upper Cover
    GM1404634Courtesy of GENERAL MOTORS CORP.
  4. Install the air cleaner upper cover and the upper cover bolts.

    Tighten:  Tighten the air cleaner upper cover bolts to 4 N.m (35 lb in).

  5. Install the air inlet duct. Refer to Air Cleaner Inlet Duct Replacement .
  6. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (L26) or Battery Negative Cable Disconnection and Connection (LY7) in Engine Electrical.
scientia non olet · About LEMON Manuals