LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CXS >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems & Power Management - Introduction >> Repair Instructions >> Ignition and Start Switch Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  3. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
    4. Fig 1: Disconnecting/Reconnecting Theft Deterrent Control Module Connector
    GM420192Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the theft deterrent control module connector.
  5. Disconnect the fused jumper assembly connector.
    6. Fig 2: Locating Theft Deterrent Module & Ignition Lock Cylinder Case Assembly
    GM324869Courtesy of GENERAL MOTORS CORP.
  6. Slide the theft deterrent control module (2) from the ignition lock cylinder case (1).
    7. Fig 3: Removing/Installing Key Alarm Connector To/From Ignition Lock Cylinder Case
    GM324871Courtesy of GENERAL MOTORS CORP.
  7. Remove the key alarm connector (1) from the ignition lock cylinder case (4).
  8. Remove the 2 tapping screws (3) from the ignition switch assembly (2).
scientia non olet · About LEMON Manuals