LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CXS >> Repair and Diagnosis (Single Page) >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems & Power Management - Service, Troubleshooting And Repair >> Delphi Connectors (Pull To Seat) >> Terminal Installation

Terminal Installation

  1. Align the terminal and pull the wire from the back of the connector in order to seat the terminal.
  2. If necessary, cut the new wire to proper length and splice with existing circuit. Refer to Splicing Copper Wire Using Splice Sleeves .
  3. If the connector is outside of the passenger compartment, apply dielectric grease to the connector.
  4. Install the TPA, CPA, and/or the secondary locks.
scientia non olet · About LEMON Manuals