LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Object Detection System) >> Repair Instructions >> Object Alarm Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying RPA Receiver & Fasteners
    GM1357202Courtesy of GENERAL MOTORS CORP.
  1. Install the RPA receiver to the rear window shelf.
  2. Install the RPA receiver fastener.
    3. Fig 2: Locating Rear Parking Assist (RPA) Receiver
    GM1357333Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector (2) to the RPA receiver.
  4. Install the rear window shelf trim panel. Refer to Rear Window Shelf Trim Panel Replacement .
  5. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals