LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Lighting Systems) >> Repair Instructions >> Brake Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Brake Pedal Position Sensor Screw
    GM1204637Courtesy of GENERAL MOTORS CORP.
  1. Apply adhesive GM P/N 12345493 (Canadian P/N 10953488) to the screw.
  2. Position the NEW sensors fork to the pin.
  3. Rotate the sensor in order to align the sensor locator to the hole in the extension bracket.
    4. NOTE: Refer to Fastener Notice .
  4. Install a NEW brake pedal position sensor bolt.

    Tighten:  Tighten the bolt to 2.0 N.m (18 lb in).

    5. Fig 2: View Of CPA Electrical Connector
    GM1204640Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector (2).

    Engage the CPA. The CPA will not engage if the connector is not attached properly.

  6. Calibrate the sensor. Refer to Brake Pedal Position Sensor Calibration .
  7. Install the I/P insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
scientia non olet · About LEMON Manuals