LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Radio Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of HVAC Control Assembly & Radio
    GM1282670Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Perform the radio set up procedure for new radios. Refer to Control Module References for programming and setup information.
  1. Remove the HVAC control assembly. Refer to Heater and Air Conditioning Control Replacement .
  2. Remove the drivers information center switch bank. Refer to Driver Information Display Switch Replacement .
  3. Remove the radio screws.
  4. Pull the radio toward you.
    5. Fig 2: View Of Instrument Panel Wiring Harness Connectors
    GM929292Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the instrument panel (I/P) wiring harness connectors and the antenna cable connector from the radio.
  6. Remove the radio.
scientia non olet · About LEMON Manuals