LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Replacement (3.8L) >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Battery Terminals & Ground Wire
    GM911131Courtesy of GENERAL MOTORS CORP.
  1. Install the insulator to the battery.
    2. IMPORTANT: Do not tip the battery more than 40 degrees during installation.
  2. Install the battery.
  3. Install the battery hold down.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the battery hold down bolt.

    Tighten:  Tighten the bolt to 18 N.m (13 lb ft).

  5. Install the positive battery terminal (1) to the battery.

    Tighten:  Tighten the nut to 15 N.m (11 lb ft).

  6. Install the right front diagonal brace. Refer to Front Fender Upper Diagonal Brace Replacement in Body Front End.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (3.8L)  or Battery Negative Cable Disconnection and Connection (3.6L) .
scientia non olet · About LEMON Manuals