LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Object Detection System >> Repair Instructions >> Object Alarm Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: RPA Receiver
    GM1357202Courtesy of GENERAL MOTORS CORP.
  1. Install the RPA receiver to the rear window shelf.
  2. Install the RPA receiver fastener.
    3. Fig 2: Locating Rear Parking Assist (RPA) Receiver
    GM1357333Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector (2) to the RPA receiver.
  4. Install the rear window shelf trim panel. Refer to Rear Window Shelf Trim Panel Replacement in Interior Trim.
  5. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals