LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Rainier 4.2 S, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 5.3L - Introduction) >> Repair Instructions >> Fuel Pressure Relief Procedure >> Tools Required

Tools Required

WARNING: This page is about a different variant/trim than selected.

J 34730-1A  Fuel Pressure Gage

    Fig 1: Identifying Fuel Pressure Gauge J 34730-1A
    GM180378Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Install J 34730-1A  . Refer to Fuel Pressure Gage Installation and Removal .
  3. Loosen the fuel fill cap in order to relieve the fuel tank vapor pressure.
  4. Open the valve on J 34730-1A  in order to bleed the system pressure. The fuel connections are now safe for servicing.
  5. Drain any fuel remaining in the gage into an approved container.
  6. Once the system pressure is completely relieved, remove J 34730-1A  .
scientia non olet · About LEMON Manuals