LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Park Avenue Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (Engine Controls - Introduction) >> Repair Instructions >> Exhaust Gas Recirculation (EGR) Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new gasket (2) on the EGR inlet pipe.
    2. Fig 1: Removing/Installing Identifying EGR Valve & Components
    GM12312Courtesy of GENERAL MOTORS CORP.
  2. Install the EGR valve (1) and two nuts (4).

    Tighten:  Tighten the nuts to 30 N.m (22 lb ft).

  3. Connect the EGR valve electrical connector.
scientia non olet · About LEMON Manuals