LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Park Avenue Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 163 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Inflatable Restraint Side Impact Sensor
    GM457510Courtesy of GENERAL MOTORS CORP.
  1. Remove any dirt, grease, or other impurities from the mounting surface.
  2. Install the SIS (2) to the center pillar sheet metal (3).
  3. Install the SIS mounting fasteners (1).

    Tighten:  Tighten the fasteners to 9 N.m (80 lb in).

  4. Install the SIS harness connector (4) to the SIS (2).
  5. Install the connector position assurance (CPA) (5) to the SIS harness connector (4).
  6. Install the center pillar trim. Refer to Garnish Molding Replacement - Center Pillar in Interior Trim.
  7. Move the seat to the original position.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2  or SIR Disabling and Enabling Zone 6 .
scientia non olet · About LEMON Manuals