Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Inflatable Restraint I/P Module Mounting Fasteners

Courtesy of GENERAL MOTORS CORP.

When installing the inflatable restraint I/P module (3) do not damage the pigtail (4).
Route the inflatable restraint I/P module pigtail (4) down through the I/P (1).
Install the inflatable restraint I/P module (3) to the I/P (1).
Install the mounting fasteners (2) that secure the inflatable restraint I/P module.
Tighten: Tighten fasteners to 9 N.m (80 lb in).

Fig 2: Removing/Installing Yellow Connector Of Inflatable Restraint I/P Module Away To/From I/P

Courtesy of GENERAL MOTORS CORP.

Route the wiring harness (2) in place to secure the yellow 2-way connector clip to the I/P (3).
Install the I/P upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper (w/o HUD) or Trim Pad Replacement - Instrument Panel (I/P) Upper (with HUD) in Instrument Panel, Gages and Console.

Fig 3: View Of I/P, Module Yellow Connector & CPA

Courtesy of GENERAL MOTORS CORP.

Clip the inflatable restraint I/P module yellow connector (2) to the I/P bracket (3).
Install the I/P module yellow connector (2) to the vehicle harness yellow connector (1).
Install the CPA (4) to the inflatable restraint I/P module connector (2).
Install the right closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5 .