LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Park Avenue Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 163 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Front End Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove any dirt, grease, or other contaminants from the mounting surface.
  2. Point the arrow on the sensor toward the front of the vehicle.
    3. Fig 1: View of CPA, Front End Sensor Wiring Harness Connector, Front End Sensor, Front End Sensor Mounting Fastener, and Key Hole Slot
    GM709876Courtesy of GENERAL MOTORS CORP.
  3. Install the front end sensor (1) horizontally into the key hole slot (2) located in the lower tie bar.

    Tighten:  Tighten the fastener (3) to 9 N.m (80 lb in).

  4. Connect the front end sensor harness wiring connector (4) to the front end sensor (1).
  5. Install the connector position assurance (CPA) (5) to the front end sensor wiring harness connector (4).
  6. Install the front air deflector. Refer to Air Deflector Replacement - Front in Body Front End.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1 .
scientia non olet · About LEMON Manuals