Visual/Physical Check

Several of the symptom procedures call for a careful visual and physical inspection. This can lead to correcting a condition without further tests and can save valuable time. This inspection should include the following areas:

Inspect the PCM grounds for being clean, tight, and in their proper location. Refer to Master Electrical Component List and Power and Grounding Connector End Views in Wiring Systems.
Inspect vacuum hoses for splits, kinks, and proper connections, as shown on Vehicle Emission Control Information label. Inspect thoroughly for any type of leak or restriction. Refer to Emission Hose Routing Diagram .
Inspect the air intake ducts for being collapsed, damaged areas, looseness, improper installation, or leaking, especially between the mass air flow (MAF) sensor and the throttle body.
Inspect for air leaks at throttle body mounting area, MAF sensor and intake manifold sealing surfaces.
The ignition wires are not cracked, brittle, or carbon tracked.
Inspect the wiring harness for poor connections, pinches, cuts, or other damage.
Inspect for loose, damaged, or missing sensors/components.

Use the following tables when diagnosing a symptom complaint: