LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> LeSabre Limited, 4T65E/MN3 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Introduction >> Repair Instructions >> Heated Oxygen Sensor Replacement - Position 2 >> Removal Procedure

Removal Procedure

  1. Turn OFF the ignition.
  2. Raise and support the vehicle.
    3. Fig 1: Removing/Installing HO2S (Position 2)
    GM402074Courtesy of GENERAL MOTORS CORP.
  3. Remove the splash shield (3).
  4. Disconnect the electrical connector retaining tab (1) from the heated oxygen sensor (HO2S) electrical connector (2).
  5. Disconnect the oxygen sensor connector (4) from the HO2S electrical connector (2).
    6. IMPORTANT: The HO2S may be difficult to remove when engine temperature is below 48°C (120°F). Excessive force may damage threads in exhaust manifold or exhaust pipe.
  6. Use the J 39194  in order to remove the oxygen sensor (4) from the exhaust pipe. See Special Tools .
scientia non olet · About LEMON Manuals