LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> LeSabre Limited, 4T65E/MN3 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Introduction >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Remove the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement in Engine Cooling.
  2. Remove the drive belt. Refer to Drive Belt Replacement (L36) in Engine Mechanical.
    3. Fig 1: Disconnecting/Reconnecting Electrical Connector To CMP Sensor
    GM389047Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector (2) from the camshaft position sensor (1).
    4. Fig 2: Removing/Installing Camshaft Position (CMP) Sensor
    GM12305Courtesy of GENERAL MOTORS CORP.
  4. Remove the camshaft position (CMP) sensor retaining screw.
  5. Remove the CMP sensor from the engine front cover.
scientia non olet · About LEMON Manuals