Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal and 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Headlamp Switch

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector to the headlamp switch.
Align the headlamp switch tabs to the I/P and press the switch into position.

Fig 2: Headlamp Switch Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the headlamp switch screws.
Tighten: Tighten the screws to 1.8 N.m (16 lb in).
Align and insert the forward edge of the left I/P access opening cover behind the hinge pillar.
Align the access opening cover retainers to the slots on the I/P trim pad and press firmly to secure.