LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Century Custom >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System And Washer System >> Repair Instructions >> Wiper Motor Replacement >> Installation Procedure

Installation Procedure

  1. Install the water shield and shaft seal onto the wiper motor.
    Fig 1: Wiper Motor & Screws
    GM815221Courtesy of GENERAL MOTORS CORP.
  2. Position the wiper motor to the wiper drive system module.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the wiper motor screws.

    Tighten:  Tighten the screws to 7 N.m (62 lb in).

  4. Install the wiper drive system module. Refer to Wiper Drive System Module Replacement .
  5. Install the wiper motor crank arm. Refer to Wiper Motor Crank Arm Replacement .
  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
scientia non olet · About LEMON Manuals