Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Regal and 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Side Rail Lamp Socket Bulb

Courtesy of GENERAL MOTORS CORP.

Install the bulb.
Install the side rail lamp socket to the base plate by sliding on.

Fig 2: Side Rail Lamp Base Plate & Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector to the side rail lamp.

Fig 3: Aligning Side Rail Lamp Base Plate To Plastic Retainers

Courtesy of GENERAL MOTORS CORP.

Align the side rail lamp base plate to the plastic retainers.

Fig 4: Removing/Installing Assist Handle

Courtesy of GENERAL MOTORS CORP.

Position the side rail lamp assist handle to the base plate and the plastic retainers.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 5: Side Rail Lamp Assist Handle Screws

Courtesy of GENERAL MOTORS CORP.

Install the side rail lamp assist handle screws.
Tighten: Tighten the side rail lamp assist handle screws to 2 N.m (18 lb in).
Close the assist handle covers pressing into place until fully seated.