LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Century Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Cellular Communication System) >> Diagnostic Information and Procedures >> DTC B2455: Cellular Phone Microphone Circuit >> Test Description

Test Description

WARNING: This page is about a different car, the 2004 Buick Regal and 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  This step checks that the Vehicle Communication Interface Module is sending out the proper supply voltage.
DTC B2455

Step Action Value(s) Yes No
Schematic Reference: OnStar Schematics 
Connector End View Reference: Cellular Communication Connector End Views 
1 Did you perform the Cellular Communications Diagnostic System Check? - Go to Step 2  Go to Diagnostic System Check - Cellular Communication 
2 
  1. Turn OFF the ignition.
  2. Disconnect the inside rear view mirror connector.
  3. Turn ON the ignition, with the engine OFF.
  4. Measure the voltage from the Cellular Microphone Signal circuit to a good ground.
Does the voltage measure greater than the specified value?		 9 V Go to Step 4  Go to Step 3 
3 Test the Cellular Microphone Signal circuit for an open or short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 9  Go to Step 6 
4 Test the drain wire circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 9  Go to Step 5 
5 Inspect for poor connections at the harness connector of the rearview mirror and harness connector of the Vehicle Communication Interface Module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 9  Go to Step 7 
6 Inspect for poor connections at the harness connector of the Vehicle Communication Interface Module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 - Go to Step 9  Go to Step 8 
7 Replace the rearview mirror. Refer to Rearview Mirror Replacement in Stationary Windows.
Did you complete the replacement?		 - Go to Step 9  -
8
IMPORTANT: Perform the OnStar® setup procedure.
Replace the Vehicle Communication Interface Module. Refer to Communication Interface Module Replacement .Did you complete the replacement?		 - Go to Step 9  -
9
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 - Go to Step 2  System OK
scientia non olet · About LEMON Manuals