Installation Procedure

WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Install the lamp, with the attached harness, to the hood.

Fig 1: Front Side Marker Lamp

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws to the lamp housing.
Tighten: Tighten the screws to 3 N.m (26 lb in).
Connect the electrical connector and secure the harness.
Close the hood.