Installation Procedure
WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the air spring level sensor to the frame.
- Install the air spring level sensor to the frame mounting bolts.
Tighten: Tighten the air spring level sensor to the frame mounting bolts to 8.5 N.m (75 lb in).
- Connect the air spring level sensor electrical connector located on the frame.
- Install the air spring level sensor link to the upper control arm.
Tighten: Tighten the bolt to 17 N.m (13 lb ft).
- Remove the rear axle support.
- Install the rear tire and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.
- Start the vehicle and run for approximately 2 minutes to ensure that the air spring leveling system is functioning properly.
- Verify the D height. Refer to Trim Height Inspection Procedure in Suspension General Diagnosis.
- Re-calibrate the trim height. Refer to Suspension Position Calibration .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.