Installation Procedure

WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Midgate Window

Courtesy of GENERAL MOTORS CORP.

Install the midgate window into the midgate though top of the midgate assembly.
Ensure the window is engaged into the window run channels.

Fig 2: Identifying Midgate Components

Courtesy of GENERAL MOTORS CORP.

Lower the window (2) onto the window regulator assembly clamps.
Install the bolts (1) retaining the midgate window to the window regulator clamps until they are finger tight.
Connect the electrical connector (3) to the defroster grid contact terminal.

Fig 3: Midgate Window Outer Sealing Strip

Courtesy of GENERAL MOTORS CORP.

Install the midgate window outer sealing strip. Refer to Sealing Strip Replacement - Midgate Window Outer .

Fig 4: Supporting Midgate

Courtesy of GENERAL MOTORS CORP.

Remove the pins (2) from the midgate hinges (1) supporting the midgate.
Close the midgate.
Operate the midgate window until the window is fully closed and engaged in the midgate weatherstrip.
Carefully lower the window in order to access the window clamp bolts.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Complete tightening of the bolts retaining the midgate window to the window regulator.
Tighten: Tighten the nuts to 5 N.m (44 lb in).
Inspect the operation of the midgate window.
Install the midgate hinge finish covers. Refer to Midgate Hinge Finish Cover Replacement in Interior Trim.

Fig 5: Midgate Inner Panel

Courtesy of GENERAL MOTORS CORP.

Install the midgate inner panel (1). Refer to Midgate Panel Replacement - Inner .