LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Allure CXS >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Body Rear End) >> Repair Instructions >> Window Channel Replacement - Midgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Midgate Window Run Channels
    GM1412517Courtesy of GENERAL MOTORS CORP.
  1. Install the midgate window run channels to the midgate.
  2. Loosely install the screws retaining the midgate window run channels to the midgate.
  3. Install the wiring harness retainer to the window run channel bracket.
    4. Fig 2: Midgate Window
    GM1412518Courtesy of GENERAL MOTORS CORP.
  4. Install the midgate window. Refer to Window Replacement - Midgate .
  5. Connect the electrical connectors.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Finish tightening the screws retaining the window run channels to the midgate.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  7. Adjust the midgate window, if necessary. Refer to Window Adjustment - Midgate .
  8. Install the midgate inner panel. Refer to Midgate Panel Replacement - Inner .
scientia non olet · About LEMON Manuals