LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Allure CXS >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Supplemental Inflatable Restraints System) >> Repair Instructions >> SIR Disabling and Enabling Zone 7 >> Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition.
    2. Fig 1: View Of Connector Position Assurance (CPA) & Steering Wheel Module Yellow 4-Way Connector
    GM819731Courtesy of GENERAL MOTORS CORP.
  2. Connect the (1) steering wheel module yellow 2-way connector (2) located left of the steering column near the knee bolster.
  3. Install the CPA to the (1) steering wheel module yellow 2-way connector (2) located left of the steering column near the knee bolster.
    4. Fig 2: Removing The Connector Position Assurance (CPA) From The I/P Module Yellow 4-Way Connector - Zone 5
    GM748421Courtesy of GENERAL MOTORS CORP.
  4. Connect the (1) I/P module yellow 2-way connector (2) located behind the I/P module.
  5. Install the CPA (1) to the I/P module yellow 2-way connector (2) located behind the I/P module.
    6. Fig 3: SIR Fuse & Underhood Fuse Block
    GM848445Courtesy of GENERAL MOTORS CORP.
  6. Install the SIR Fuse (1) into the underhood fuse block.
  7. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
    1. The AIR BAG indicator will flash 7 times.
    2. The AIR BAG indicator will then turn OFF.
  8. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information if the AIR BAG indicator does not operate as described.
scientia non olet · About LEMON Manuals