LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Allure CXS >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Steering Wheel And Steering Column) >> Repair Instructions >> Multifunction, Turn Signal Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Turn Signal Switch Assembly
    GM761439Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The electrical contact on the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.
  1. Install the turn signal and multifunction switch assembly.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure by using 2 pan head tapping screws.

    Tighten: 

    • Tighten the screw on the top of the column to 3 N.m (27 lb in).
    • Tighten the screw on the side to 7 N.m (62 lb in).

  3. Connect the connectors to the turn signal and multifunction switch assembly.
  4. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals