LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Allure CXS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.6L (Ly7) - Introduction (2 Of 2) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

  1. Carefully clean the throttle body mounting surfaces of any gasket and/or seal material.
    2. Fig 1: View of Throttle Body
    GM1580583Courtesy of GENERAL MOTORS CORP.
  2. Install the throttle body and NEW gasket.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the throttle body bolts.

    Tighten:  Tighten the throttle body bolts to 10 N.m (89 lb in).

    4. Fig 2: Identifying Throttle Body Electrical Connector
    GM1394050Courtesy of GENERAL MOTORS CORP.
  4. Install the throttle body electrical connector.
  5. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
  6. Perform the idle learn procedure. Refer to Idle Learn Procedure .
  7. Use the scan tool to clear all DTCs.
scientia non olet · About LEMON Manuals