LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Allure CX >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.8L - Introduction (2 Of 2) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 3.8L.
  2. Disconnect the MAP sensor electrical connector.
    3. Fig 1: Removing/Installing Manifold Absolute Pressure (MAP) Sensor (VIN K)
    GM12346Courtesy of GENERAL MOTORS CORP.
  3. Carefully release the locking tabs holding the MAP (1) sensor to the PCV valve cover (2) just enough to remove the MAP sensor.
  4. Pull the MAP sensor straight out of PCV valve cover.
scientia non olet · About LEMON Manuals