LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2005 >> Allure CX >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.8L - Introduction (2 Of 2) >> Repair Instructions >> Ignition Coil(s) Replacement >> Installation Procedure

Installation Procedure

  1. Install the ignition coil (2).
    2. Fig 1: View Of Ignition Coil Module And Module Mounting Bracket
    GM12299Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ignition coil screws (1).

    Tighten:  Tighten the screws to 4.5 N.m (40 lb in).

  3. Connect the spark plug wires.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals