LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Park Avenue Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Shift Interlock System >> Repair Instructions >> Automatic Transmission Shift Lock Actuator Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Automatic Transmission Shift Lock Control Actuator
    GM324906Courtesy of GENERAL MOTORS CORP.
  1. Install the automatic transmission shift lock control to the steering column jacket assembly.
    2. Fig 2: Adjusting Automatic Transmission Shift Lock Control Actuator
    GM324912Courtesy of GENERAL MOTORS CORP.
  2. Adjust the automatic transmission shift lock control.
    1. Pull the tab (1) out on the block (2) side of the automatic transmission shift lock control.
    2. Shift the column into the NEUTRAL position.
    3. Press on the adjuster block (2) to compress the internal adjuster spring to disengage the adjuster teeth. Slide the adjuster block (2) as far away from the solenoid as possible.
    4. Shift the column into NEUTRAL.
    5. Lock in place by pushing the tab (1) back in.
  3. Inspect the automatic transmission shift lock control.
    1. The automatic transmission shift lock control must lock the gear shift lever when it is put into the PARK position.
    2. When the column is installed in the vehicle you will not be able to shift the gear shift lever out of the PARK position without pressing on the brake pedal. The solenoid will be energized.
    3. Readjust if needed.
  4. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals