LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> Century Custom >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - 4T65-E (Introduction) >> Repair Instructions >> Park Lock Cable Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the front floor console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages and Console.
  3. Remove the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
  4. Place the transaxle shift control lever in the PARK position.
    5. IMPORTANT: Ensure the ignition key is in the RUN position. Do NOT attempt to proceed to the next step with the key in any other position.
  5. Turn the ignition key to the RUN position.
  6. Slip a screwdriver blade into the slot provided in the ignition switch inhibitor.
  7. Use the screwdriver to depress the cable latch.
  8. Pull the cable from the inhibitor.
  9. Remove the park/lock cable at the shift control.
    10. Fig 1: View Of Park/Lock Cable & Retainer
    GM161186Courtesy of GENERAL MOTORS CORP.
  10. Remove the cable retainer from the park/lock cable at the shift control.
  11. Remove the park/lock cable.
scientia non olet · About LEMON Manuals